The VAZ 2110 mounting block can be removed and installed using generally accepted information about this operation in practice. If the current-carrying tracks located on the printed circuit board are burned out, then there is the possibility of soldering the necessary wires.
Removing the mounting block: work schedule
1. From the storage battery, it is necessary to disconnect the wire from this terminal with a negative sign of the output.
2. Next, you need to slightly open the cover of this mounting block of the car, then unscrew the screw securing it with a Phillips screwdriver. 3. Then you need to pull out the box with the fuses by pulling it towards you.
4. Then it will be necessary to detach the pads with the attached wires from the unit.
5. Further, it is advised to tie up the existing wires with insulating tape in a bundle.
6. Finally, you will need to remove the cover of the mounting block, while unscrewing a couple of screws securing the bracket hinges.
It is also recommended: to mark the pads with the attached wires - this action will significantly facilitate the work with the subsequent reinstallation and installation of a new one.
Where can the rear fog lamp fuse be located?
This fuse for the fog lights of a VAZ 2110 car is installed on the instrument panel in the place next to the fuse box.
Price for a new mounting block for VAZ 2110:
- AVAR has a cost of 178,540 rubles;
- The price for a mounting block of a new sample - VAZ 2110 TOCHMASH (rated voltage 12V) - 2080 rubles. It is also suitable for VAZ 2111, 2112, 2123, 1118.
